Sangoma S5145 56k/DDS Serial Card

Technical Specifications

• One 56/64kbps DDS line interface, one Secondary RS232 port to 128kbps for ISDN or dial backup
• Power: 550mA at +5v
• PCI 32 bit 5v. Optionally available in 5v/3/3v configuration.
• Temperature range: 0 - 45C
• All set-up and configuration is in software or by machine BIOS.
• DSU/CSU set up entirely in software.
• 56kbps DDS compatible with Bellcore standards
• Network or internal clocking for back to back test setups
• Software controlled DSU/CSU test modes
• Remote monitoring of card and CSU/DSU operation
• Dimensions: 170mm x 99 mm

DDS status reports

• DMI: Receiving Data Mode Idle
• ZSC: Receiving Zero Code Suppression
• CMI: Receiving Control Mode Idle
• OOS: Receiving Out of Service
• OOF: Receiving Out of Frame
• DLP: Receiving DSU Non-Latching loopback code
• UMC: Receiving Unassigned MUX Code
• RLOS: Receive Loss of Signal

Line protocols
Frame Relay, X.25, HDLC, PPP, SS7, Transparent bit-stream, BSC.

Operating systems
Windows® 2000, Windows® XP, Windows® 9x, Windows® ME, Linux (all versions, releases and distributions from 1.0 up), FreeBSD, Open BSD, NetBSD.

Higher level protocols
IP/IPX over Frame Relay/ PPP/ HDLC/ X.25, X.25 over Frame Relay (Annex G), BSC over X.25 (DMT and TCOP), SNA over X.25

Warranty
Three years parts and labour.

Diagnostic Tools
WANPIPEMON, SNMP, System logs.

Production quality
ISO 9002

RJ 45 Pin-out

Typical Applications:

1. WANPIPET WAN router replacement at the network edge

To Replace